Error message: Failed to log in to target. Write-Host "Synchronizing: $($syncPercent)%" -foreground yellow $syncPercent = $device.GetPropertyValue("ha_synch_percent") $device = Add-HADevice -server $server -firstNode $firstNode -secondNode $secondNode -initMethod "Clear"
![starwind san starwind san](https://i.ytimg.com/vi/9TYr4-A5o4c/maxresdefault.jpg)
You do not need to specify it for second node
STARWIND SAN SERIAL
# Note: Second node always has the same serial ID. If it not specified StarWind Service will generate it. # 'SerialID' should be between 16 and 31 symbols. Possible values: 512 or 4096(May be incompatible with some clients!) bytes. # partner heartbeat interface (second node) # partner synchronization interface (second node) # iSCSI target alias (lower case only supported because of RFC) # Specify the path where image file is stored $server = New-SWServer -host 127.0.0.1 -port 3261 -user root -password starwind #specify the IP address and credential (this is default cred) of a first node Problem is, my HA Devices doesnt´t sync anymore after shutdown of both nodes. I got a problem with my VSAN konfiguration.
![starwind san starwind san](https://www.vladan.fr/wp-content/uploads/images/StarWind-virtual-SAN-720x310.jpg)
![starwind san starwind san](https://charbelnemnom.com/wp-content/uploads/2014/09/StarWind-Virtual-SAN-breakdown-session_FB.png)
StarWind Virtual Tape Library Appliance (VTLA).StarWind HyperConverged Appliance (HCA).